ORG NR 885 947 522
Produktkode: 516
Tilgjengelighet: Forhåndsbestilles
Ring etter pris: 91166668
PX4 Pixhawk V2.4.6 32Bits Open Source Flight Controller w/External LED for RC Airplanes
Improvements on V2.4.5
- V2.4.6 PCB board
- Redeveloped and optimized circuit without changing components
- Could use Official MissionPlanner, ECLIPSE firmware upgrade
- 168 MHz / 252 MIPS Cortex-M4F
- 14 PWM / Servo outputs (8 with failsafe and manual override, 6 auxiliary, high-power compatible)
- Abundant connectivity options for additional peripherals (UART, I2C, CAN)
- Integrated backup system for in-flight recovery and manual override with dedicated processor and stand-alone power supply (fixed-wing use)
- Backup system integrates mixing, providing consistent autopilot and manual override mixing modes (fixed wing use)
- Redundant power supply inputs and automatic failover
- External safety switch
- Multicolor LED main visual indicator
- High-power, multi-tone piezo audio indicator
- microSD card for high-rate logging over extended periods of time
- 32bit STM32F427 Cortex M4 core with FPU
- 168 MHz
- 256 KB RAM
- 2 MB Flash
- 32 bit STM32F103 failsafe co-processor
- ST Micro L3GD20H 16 bit gyroscope
- ST Micro LSM303D 14 bit accelerometer / magnetometer
- MEAS MS5611 barometer
- 5x UART (serial ports), one high-power capable, 2x with HW flow control
- 2x CAN (one with internal 3.3V transceiver, one on expansion connector)
- Spektrum DSM / DSM2 / DSM-X® Satellite compatible input
- Futaba S.BUS® compatible input and output
- PPM sum signal input
- RSSI (PWM or voltage) input
- I2C
- 3.3 and 6.6V ADC inputs
- Internal microUSB port and external microUSB port extension
Power System and Protection
- Ideal diode controller with automatic failover
- Servo rail high-power (max. 10V) and high-current (10A+) ready
- All peripheral outputs over-current protected, all inputs ESD protected
Package Included:
- PX4 V2.4.6 Flight board (with original DF13 connector )
- safety switch
- Buzzer
- Original Case
- 4GB SD Card
- SD Card Adapter
External LED light board (with USB function) x1
- Pixhawk-I2C Splitter Expand Module  X  1pcs
- PPM module x1 
- Power Module x1
- Minim OSD x1
- 433 telemetry x1
- M8N GPS X1
- Gps stander holder x1 
- 4 Pin DF13 cable x1
- 5 pin DF13 cable x1
- 6 pin DF13 cable x1 
- Compare to the old version 2.4.5, the final release 2.4.6 Version is added two components: D1002 and F1002
- D1002 model: PMEG2005CT
- This version of flight control can solve the problem of small supply current for receiver, and the flight control system halted caused by overcurrent supply
If you need Minim OSD  :
Damping plate :
PPM encloser:
Power module :
I2C Board:                   
RGB USB Module:     
High Quality 7N GPS: 
Det er ingen tilbakemeldninger for dette produktet
Skriv en tilbakemelding

Søk etter produkt