skule.sormo.no

ORG NR 885 947 522

http://schema.org/InStock
Motor Driver Shield for WEMOS D1 Mini and Compatible Microcontrollers
This D1 Mini Motor Driver Shield uses the Toshiba TB6612FNG motor driver chip to control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop.
 
The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby mode.
All pins of the TB6612FNG are broken out to two 0.1" pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.
 
Features and Specifications:
I2C interface
Power supply voltage: VM=15V max
Output current: Iout=1.2A(average) / 3.2A (peak)
Standby control to save power
CW/CCW/short brake/stop motor control modes
VM: Motor Power Supply +
GND: Motor Power Supply -
A1, A2: Motor A
B1, B2: Motor B
S: Stand by control port (In IO mode)
Standby control mode (Set with jumpers on the back side of the board)
  • I2C mode: Control TB6612's STBY with I2C protocol
  • IO mode: Control TB6612's STBY with "S" pin
Shield reset mode (Set with jumpers on the back side of the board)
  • Shorted: reset with D1 Mini (reset at power on or press D1 Mini's reset button)
  • Open: reset by "DTR" pin.
I2C Address
AD1 AD0  Address
   -        -        0x2D
   -        x       0x2E
   x       -        0x2F
   x       x       0x30
Package Includes:
1x Motor Driver Shield for Wemos D1 Mini
3x 8P 2.54mm pins
1x 9P 2.54mm pins

Det er ingen tilbakemeldninger for dette produktet
Skriv en tilbakemelding
DårligUtmerket
Facebook-kommentar

Søk etter produkt

Handlekurv